
Guides
Part of Apartment EV charger sensitivity analysis: how one input change shifts a 2027 decision
Apartment EV charger cost scenarios: how to keep 2027 planning views separate
Apartment EV charger cost scenarios for 2027 compare 4-port, 8-port, and 12-port views with named hardware prices and keep provider terms separate.
What to take away
- A 4-port assigned setup plans near $13,600 in these views. An 8-port networked build plans near $62,000. A 12-port build runs from about $42,400 to $89,000.
- Hardware is the smaller line. Make-ready is $12,000 for four ports, $22,000 for eight and $35,000 for twelve.
- Per-port totals land near $3,400 to $3,650 for assigned charging and $7,400 to $7,750 for networked commercial charging.
- Every figure below is a planning placeholder, not a provider quote and not an approved budget.
- The right scenario turns on who pays for electricity and whether tenants need per-session billing.
The six 2027 views side by side
Read the table by port count and by the make-ready line. Make-ready follows trenching, panel capacity and conduit runs. NFPA 70 sets the installation requirements behind that work, so the line moves less than hardware when brands change.
Ports
- Assigned spots, Emporia Level 2
- 4
- Assigned spots, Wallbox Pulsar Plus
- 4
- Networked, ChargePoint CP6000
- 8
- Host-owned, Blink IQ 200
- 8
- Capacity first, Tesla Universal Wall Connector
- 12
- Networked, ABB Terra AC or Siemens VersiCharge AC
- 12
Hardware
- Assigned spots, Emporia Level 2
- $1,600
- Assigned spots, Wallbox Pulsar Plus
- $2,600
- Networked, ChargePoint CP6000
- $40,000
- Host-owned, Blink IQ 200
- Host may fund
- Capacity first, Tesla Universal Wall Connector
- $7,440
- Networked, ABB Terra AC or Siemens VersiCharge AC
- $54,000
Make-ready
- Assigned spots, Emporia Level 2
- $12,000
- Assigned spots, Wallbox Pulsar Plus
- $12,000
- Networked, ChargePoint CP6000
- $22,000
- Host-owned, Blink IQ 200
- $22,000
- Capacity first, Tesla Universal Wall Connector
- $35,000
- Networked, ABB Terra AC or Siemens VersiCharge AC
- $35,000
Planning total
- Assigned spots, Emporia Level 2
- $13,600
- Assigned spots, Wallbox Pulsar Plus
- $14,600
- Networked, ChargePoint CP6000
- $62,000
- Host-owned, Blink IQ 200
- Open until quoted
- Capacity first, Tesla Universal Wall Connector
- $42,440
- Networked, ABB Terra AC or Siemens VersiCharge AC
- $89,000
Per port
- Assigned spots, Emporia Level 2
- $3,400
- Assigned spots, Wallbox Pulsar Plus
- $3,650
- Networked, ChargePoint CP6000
- $7,750
- Host-owned, Blink IQ 200
- Open
- Capacity first, Tesla Universal Wall Connector
- $3,537
- Networked, ABB Terra AC or Siemens VersiCharge AC
- $7,417
The three port counts stay separate on purpose.
2027 Apartment EV Cost Scenarios
4-port assigned
- Hardware
- $1,600
- Make-ready
- $12,000
- Planning view
- $13,600
- Key limit
- No payment network
8-port commercial
- Hardware
- $40,000
- Make-ready
- $22,000
- Planning view
- $62,000
- Key limit
- Dated quote needed
12-port expansion
- Hardware
- $7,440
- Make-ready
- $35,000
- Planning view
- $42,440
- Key limit
- No usage billing
Provider totals arrive with an approval state attached. The guide to apartment EV charger cost approval status in 2027 shows how to label a number before a budget meeting.
Where the hardware prices come from
- Emporia Level 2 units run about $400 each. They are 48-amp chargers for assigned spots with free charging, and they are not a billing platform.
- Wallbox Pulsar Plus units run about $650 each and add app control for simple reporting. They are not full commercial billing either.
- ChargePoint CP6000 ports are quoted per site, often with a software subscription. Ask for a dated quote and the service term.
- Blink IQ 200 comes in host-owned and Blink-owned models. Under the Blink-owned model, Blink may fund hardware and share revenue, so the hardware line stays open.
- Tesla Universal Wall Connectors run about $620 each, support 48 amps, and take both NACS and J1772 plugs. They carry no built-in payment.
- ABB Terra AC Wallbox and Siemens VersiCharge AC units typically quote from about $1,500 to $2,500 per port before network fees and warranty.
Which scenario fits which property
- Four to six assigned spots and the owner covers electricitythe Emporia or Wallbox path.
- Eight to twelve shared spots where tenants pay per sessionthe ChargePoint or ABB path, with subscription costs added.
Before you fix a port count, write down the service capacity you already have. Our notes on apartment EV charger capacity scenarios list what to document before you plan.
- An owner who will not fund hardwarethe Blink-owned path, if the service term and revenue split work.
- A property adding capacity before billingthe Tesla path, with metering added later.
- A site with mixed NACS and J1772 carsany 8-port or 12-port path, since all of them carry both plug types.
Keep provider quotes out of the placeholders
- Label each figure as a placeholder, a quote or an assumption.
- Attach the source document and its date to every provider number.
- Leave excluded items marked as excluded instead of counted as zero.
- Record funding outcomes in their own field. The DOE state laws and incentives directory points to program leads, but it does not decide your award.
Who pays is a separate question from what the hardware costs. Some owners fold charging into rent on assigned spots. Others bill per session through the network. State rules on submetering and billing in rental housing vary, so check the state summary before you promise tenant billing.
Before a vote, settle what counts as authorization. The apartment EV charger project authorization guide sets out what to decide before approval.
When a provider revises a price
- Keep the earlier scenario intact and write the revision date beside it.
- Build a new dated scenario that carries the changed figure.
- Put the changed input in the scenario title, not in a footnote.
- Check that the make-ready line still matches the new amperage or port count.
- Tell the property which pending decisions the revision touches.
A revision rarely stays alone. A higher per-port price can push the service upgrade, the panel work and the tenant rate at the same time.







